How to clean switchboards at home: Despite regular home cleaning, one thing often goes unnoticed: the switchboard. Over time, they accumulate a layer of dust, dirt, fingerprints, and yellowing, making them look old and dirty even after the entire room is cleaned. Fortunately, there is no need to buy expensive chemical cleaners to clean them. A few common household items can help restore their shine.

White toothpaste is the easiest solution

If the switchboard is slightly dirty or yellow, white toothpaste may be the easiest solution. Apply a small amount of toothpaste to an old toothbrush and gently scrub the switchboard, especially the edges and corners. Then, wipe it off with a dry, clean cloth. Within minutes, the switchboard will look cleaner and shinier than ever. For best results, use regular white toothpaste instead of gel toothpaste.

A mixture of lemon and salt

If the dirt is very ingrained, a mixture of lemon and salt may prove effective. The natural acid in lemon helps loosen stubborn dirt, while the salt acts as a gentle scrubber. Sprinkle some salt on half a cut lemon and rub the switchboard gently with it. Then, wipe it with a dry cloth. This method helps to clean the plastic without damaging it.

Use of nail polish remover

Some switchboards may have ink marks, black stains, or stubborn old stains that are difficult to remove. In this case, a small amount of nail polish remover can be applied to a cotton ball or a soft cloth and gently wiped over the stained area. The acetone in the product helps remove tough stains. However, use a very small amount and test it on an inconspicuous area first, as excessive amounts can affect the plastic finish.

This is important to keep in mind

It is very important to take special safety precautions while cleaning the switchboard. Switch off the relevant power supply before starting cleaning. Always stand in a dry place and wipe with dry hands. Never use wet cloths or excess water. When using any liquid such as lemon juice or nail polish remover, make sure the switchboard is completely dry before turning on the power. Also, never touch switchboards, plugs or wires with wet hands or bare feet. Avoid using excessive liquids around any electrical device.