Immersion Rod Safety Tips: Everyone is afraid of bathing with cold water in the winter season. Some people get geysers fitted due to the fear of bathing with cold water, but geysers are very expensive and not everyone can afford them. In such a situation, immersion rod is an economical and convenient way to heat water, especially in places where geysers are not available.

However, sometimes accidents may occur during its use. Therefore, it is important to take safety precautions while heating water with an immersion rod. Let us know what precautions should be taken while using immersion rod.

These things should be kept in mind while buying immersion rod

Brand and quality

Always choose a trusted and well-known brand. Rods of good brands are made as per safety standards and there is less risk of short circuit.

Click to know health news-

Power capacity

Choose the power capacity of the water heating rod as per your need. Generally, a 1000 to 2000 watt rod is sufficient for home use.

ISI mark

Always buy ISI certified rods only. It is guaranteed to be safety and of good quality.

Materials and Coatings

The material of the rod should be such that it does not rust in water. Stainless steel or copper rods are considered the best. The upper part of the rod should be made of strong plastic, which should not melt due to overheating.

Know the precautions to be taken while using the heater

use with dry hands

Hands should be completely dry while heating water. Plugging or unplugging the rod with wet hands may result in electric shock.

use plastic bucket

Always use water heating rods in a plastic bucket. Using it in a metal bucket can be dangerous.

keep the right amount of water

There must be enough water in the bucket to completely submerge the heating part of the rod. If part of the rod remains outside, it may overheat and burn. Minimum and maximum watermarks are mentioned on the rod. Fill water in the bucket accordingly.

Click to know religious news-

check electrical connections

The plug of the rod should be in the correct position. If any wire is cut or damaged, get it replaced immediately. Do not switch on the immersion rod before putting it in water and always take the rod out only after switching it off.